This device complies with the radio interference requirements of the European Community.

Hereby, KAWA ELECTRONICS COMPANY LIMITED declares that the radio equipment type Baby Monitors S6 is in compliance with Directive 2014/53/EU.The full text of the EU declaration of conformity is available at the following internet address: www.kawa-in.com 

The product shall only be connected to a USB interface of version
USB2.0 or higher and that the connection to a power USB is prohibited.

Caution:
For Adapter: Shall be installed near the equipment and shall be easily accessible.
For Battery: Risk of explosion battery is replaced by an incorrect type,
dispose of used batteries according to the instructions. To prevent possible hearing damage, do not listen at high volume levels for long periods.

Operating Frequency Range: 2400 – 2483.5MHz

Transmit Output Power: 21 (+1/-2) dBm @ Maximum Power Setting

Only can use the adapter as below:
S6-M: Rated Input & Output: AC100V-240V, 50/60Hz, 200mA, DC5.0V, 2A.
S6-C: Rated Input & Output: AC100V-240V, 50/60Hz, 200mA, DC5.0V, 1A.
Manufacturer: KAWA ELECTRONICS COMPANY LIMITED
Model Name: Baby Monitor S6
The plug could be disconnected from adapter.

FCC Statement

NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.However, there is no guarantee that interferencewill not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party

responsible for compliance could void the user's authority to operatethe equipment. This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.

CC RF Exposure Warning Statements:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment shall be installed and operated with minimum distance 20cm between the radiator & body.

This device contains licence-exempt transmitter(s)/receiver(s) that
comply with Innovation, Science and Economic Development \ Canada’s licence-exempt RSS(s). Operation is subject to the
following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device.

L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
(1) L' appareil ne doit pas produire de brouillage;
(2) L' appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d' en compromettre le fonctionnement.

FCC ID(S6-M): 2AZWZ-S6M
FCC ID(S6-C ): 2AZWZ-S6C

Radio Frequency Exposure Statement for IC:

This equipment complies with IC exposure limits set forth for an uncontrolled environment. This equipment shall be installed and operated with minimum distance 20cm between the radiator & body.

Cet équipement est conforme aux limites d'exposition IC
définies pour un environnement non contrôlé. Cet équipement doit être installéet utilisé avec une distance minimale de 20 cm entre le radiateur et la carrosserie.

IC(S6-M): 27280-S6M
IC(S6-C): 27280-S6C

Please use the standard AC Power Chargers and Micro USB Charging Cables.Do not use the device in an environment where the temperature is too high or too low, and do not expose the device to strong sunlight or an environment that is too humid. The suitable ambient temperature for S6-M and accessories is -20°C to +45°C. The suitable ambient temperature for S6-C and accessories is -20°C to +40°C.When charging, please place the device in a well-ventilated environment with normal room temperature. It is recommended to charge the device within the temperature range of 0°C~45°C.

This product is designed and manufactured with high quality materials and components, which can be recycled and reused.

This symbol indicates that the product must not be discarded as household waste, and should be delivered to an appropriate collection facility for recycling. Proper disposal and recycling helps protect natural resources, human health and the environment. For more information on disposal and recycling of this product, contact your local municipality, disposal service, or the shop where you bought this product.

Warranty:12-month limited warranty

Manufacturer: KAWA ELECTRONICS COMPANY LIMITED

Email: support@kawa-in.com
Web: www.kawa-in.com
Address: FLAT A 21/F CHEUNG LEE IND BLDG 9 CHEUNG LEE ST CHAI WAN HONG KONG

Pre-loader